1. The slewing ring had been filled a few of No.3 lithium ased grease in the race before delivery. Consumers should fill the new grease suitably according to different working condition before use it. Generally, it is necessary to fill in grease once every 100 hours for ball slewing ring. When filling in lithium based grease, it must make the grease even till the grease out off from the sealing. The filling period should be shorten ifthere is the special working condition such as at the torrid zone, high humidity, severe dust, large temperature variation and long continuing working time.
2. It should be filled with new grease before and after the machine being long time stop working.
3. The gear faces exposed in air should periodically cleaned and spread with appropriate oil on it.
4. In general working condition, check the pretightening force of the bolts after first 100 working hours then check it every 500 hours of the slewing ring. It must be always kept enough pretightening force.
5. Cleaning the slewing ring with high-pressure water is not permissible during operation so as to avoid the water entering to the rolling race.
6. Stop and check the machine during operation if there is abnormal noise, vibration occurred or suddenly power rose. Remove the trouble or dismantle it for repairing if necessary.
7. Should nit let the hard materials access or enter in the engaging area of the gear.
8. Regularly check the seal ring is that OK or not. Replace it if it is damaged and reset it when it is fallen.
9. Multi-slewing rings overlapping together horizontally must put at least 3-5 pads evenly in the direction of circumference between the slewing rings. And the upper and lower pads put in the circumferential direction of the position should be consistent. Slewing ring stand up is prohibited.
10. Slewing ring should be placed on non-corrosive medium, and stored in dry, flat indoor room, cannot be soaked or watered.